Notes ceramic mill equipment before starting: 1. Ceramic ball before start, should carefully check all bolts, whether village board bolts are tightened, each mill warehouse doors are installed and fixed firmly obstacles impede the operation of equipment must be cleaned, all lubrication points lubricant (grease) Be sure to add a little, if the ambient temperature is below -10 C (eg winter), do not pass into the cooling water inside the main bearings, main bearings while heating oil tank (heating with alcohol burner), with lower oil The viscosity, of course, but also the speed reducer in oil heated to restore its liquidity, the gear would otherwise poor lubrication for dry ball mill, shortly after the start, they have to immediately pass into the cooling water. 2. Before the ball starts to check the electrical equipment and the signal system is intact. www.zzyuxi.com 3. Former mill equipment started, hit the bell to warn newspaper to prevent unauthorized personnel or pedestrians approaching ball mill beneficiation, accidents. Gu will be noted that, in the open ground each season, some factories will be the main bearings and gear oil temperature was too high, and this is inappropriate, generally will have condensation or too sticky oil is heated to 20-3D ℃ can be. Cone Mill equipment maintenance tips: 1. All lubricants in a ball into a month of continuous operation should release all Cone Mill, thoroughly cleaned, replaced with new oil mill, after binding rounding oil change once every six months, each lubrication point lubrication situation and the oil level checked at least once every four hours. www.zzyuxi.com 2. When the cone mill operation, the main bearing lubricant temperature rise should not exceed 55 ℃, when the cone mill normal operation temperature bearings and gear drives should not exceed 55 ℃, the maximum shall not exceed 60 ℃. 3. Cone Mill large and small gear transmission smooth, no abnormal noise, when necessary, to adjust the gap, smooth dry ball mill ball mill operation, no strong vibration, motor current should be no abnormal fluctuations. 4. Cone Mill no loose fasteners each connection, no combination of surface oil spills, no evasion water, mineral seamless phenomenon, according to the wear of the ball in time to add, if you do not normally find ball mill overhaul should be stopped immediately. 5. The liner is worn 70% or 70mm long crack should be replaced, liner bolts for damage caused by loose liner should be replaced, should replace badly worn main bearings. 6. Cone Mill Great gear surface wear to a certain extent can continue to be used upside down, pinion severe wear should be replaced. 7. Cone Mill should wear timely access to material spiral welding, welding should not be worn to replace anchor bolts loose or damaged should be repaired. For cleaning and maintenance, it is generally in accordance with the mill's normal cleaning intervals do cleaning work, but if too much dust or dust operating environment, cleaning and maintenance intervals should be shortened, for example, the work of the air filter cleaning and changing oil will be based on the amount of dust and flexible work environment to change the cleaning interval, when the workload, you can maintain a corresponding increase in frequency, in order to avoid some of the machinery accidents. Energy saving ball mill, ball mill, Xining City, Dahua mill provided by Gongyi City Dahua Machinery Limited. Gongyi City Dahua Machinery Co., Ltd. (www.dhqmj.com/) strong, credible, in Zhengzhou, Henan's industry-specific equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Dahua machinery and you hand into the brilliant, for a better future!