Note mill equipment operation during the operation before the mill, and after the operation, must be checked. (1) Note mill equipment lubrication and cooling during normal operation. (2) to observe whether the smooth functioning ball mill, the amplitude of the main bearings must not exceed 0.1mm. (3) The main bearing mill equipment during the operation temperature not exceeding 60 degrees C. Sealing is good throughout the period (4) runs the ball mill should be seamless gray, oil spills, leaks. (5) Check all coupling bolts, anchor bolts and ball mill equipment cylinder liner bolts are loose, loss, broken. (6) To observe the motor and control system should be normal, operation and mill supply voltage should be within the specified range. (7) Check the high voltage floating or system is normal, start control is sensitive. (8) Check the signal device is sensitive. (9) gear, the gear unit and the motor, please check in accordance with their relevant specifications and drawings. (10) mill equipment operation to observe the hollow shaft, the oil ring is rotating with oil, the hollow shaft temperature is normal, if found hollow shaft fever, close to bush-burning, forced cooling measures should be taken immediately, shall immediately shut down, so as to avoid "axle" while careful to check each mill lubrication oil, temperature, time to refuel. Notes ceramic mill equipment before starting: 1. Ceramic ball before starting, should carefully check the connection bolts, whether the village board bolts are tightened, each mill warehouse doors are installed and fixed firmly obstacles impede the operation of equipment must be cleaned, grease all lubrication points (grease) Be sure to add a little, if the ambient temperature is below -10 C (eg winter), do not pass into the main cooling water wet ball bearings, main bearings while heating oil tank (heating with alcohol burner) to reduce Cone Mill lubricating viscosity, of course, but also the speed reducer oil heating, to restore its liquidity beneficiation mill, otherwise the gear will be poor lubrication for dry ball mill, shortly after the start, they have to immediately pass into the cooling water. 2. Before the ball starts to check the electrical equipment and the signal system is intact. www.zzyuxi.com 3. Former mill equipment starts, hit the bell to warn newspaper, to prevent unauthorized personnel or pedestrians near the mill accidents. Gu will be noted that, in the open ground each season, some factories will be the main bearings and gear oil temperature was too high, and this is inappropriate, generally will have condensation or too sticky oil is heated to 20-3D ℃ can be. Mill price, Ganzhou ball, UOB machinery provided by the Gongyi City Dahua Machinery Company Limited. Gongyi City Dahua Machinery Co., Ltd. (www.dhqmj.com/) strong, credible, in Zhengzhou, Henan's industry-specific equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Dahua Machinery and you work into the brilliant, for a better future!